Glitz and glamor for the shoe cabinet!

Glitz and glamor for the shoe cabinet!

Elegant. Expressive. Individual. You want your interior to be just like you, and you have a taste for a little glamor now and again? Then try out our shoe cabinet makeover, because with the help of the d-c-fix Metallic Ornament adhesive foil, you can create some glitzy accents in your home. And best of all: This DIY takes up little time and is not too costly. Ready for the wow effect? Then get started now!

Preparation

15 min

Time

30 min

Difficulty

Easy

Cost

Low

You will need:

  • d-c-fix Metallic Ornament
  • d-c-fix application kit with doctor blade & utility knife
  • Pencil
  • Tape measure
  • Scissors
Preparation

15 min

Time

30 min

Difficulty

Easy

Cost

Low

Step by step guide for your shoe rack with that wow effect

Fronts of the shoe cabinet are measured.
Step 1

Clean the cabinet fronts, remove the knobs and then measure the fronts.

The adhesive foil is cut with scissors.
Step 2

Transfer the measurements to the backing paper of the adhesive foil and cut these out. Be very careful, because the surface of the film is very sensitive.

Adhesive foil is smoothed down on the cabinet fronts.
Step 3

Peel off the backing paper and apply the adhesive foil firmly onto the cabinet front. Here, too, a cautious approach is required.

Excess adhesive foil is trimmed away with a utility knife.
Step 4

You can trim off any excess adhesive foil using the utility knife.

Knobs are screwed onto the fronts.
Step 5

Finally, attach the knobs back onto the shoe cabinet.

You did it!